Recalls: Mountain Climbing
The sit harnesses are worn around climber's waist and legs and attach to climbing ropes to protect climbers from falling. The harnesses have three buckles including one on the waist belt and one on each leg loop. "Edelweiss" is printed on the waist belt. Only harnesses using the para buckle system are included in this recall. Para buckle harnesses have a single bar installed in the center of each of the three buckles. Read more.
The recall involves the M34 BL Am'D Ball-Lock and M36 BL William Ball Lock carabiners with metal locking sleeves. Carabiners with batch number between 06076 and 06178 are included in the recall. The batch number is engraved on the spine of the carabiner. The recall does not include Ball Lock carabiners having a plastic locking sleeve. Read more.
These cable assemblies are used by wall climbers in auto-belay and auto-zip devices to prevent a climber from free-falling. The cable assemblies are made up of a stainless steel cable eye, and 1/4-inch galvanized wire rope. The recalled cable assemblies have a date codes 1-06, 2-06, or 3-06 etched onto the cable eye. Read more.
Full-Body Safety Harnesses Recalled for Fall Hazard NEWS from CPSC U.S. Consumer Product Safety Commission Office of Information and Public Affairs Washington, DC 20207 FOR IMMEDIATE RELEASE Originally issued June 8, 2006, Revised October 25, 2007 Release #06-183 Firm's Recall Hotline: (800) 353-0634 CPSC Recall Hotline: (800) 638-2772 CPSC Media Contact: (301) 504-7908 Note: phone number change. Full-Body Safety Harnesses Recalled for Fall Hazard WASHINGTON, D.C. - The U.S. Consumer Product Safety Commission, in cooperation with the firm named below, today announced a voluntary recall of the following consumer product. Consumers should stop using recalled products immediately unless otherwise instructed. It is illegal to resell or attempt to resell a recalled consumer product. Name of Product: Safety Harnesses Sold with Hunting Tree Stands Units: About 106,000 Distributor: Summit Treestands LLC, of Decatur, Ala. Hazard: The harnesses could fail during use, resulting in consumers falling from tree stands and suffering serious injuries or death. Incidents/Injuries: None reported. Description and Models: The harnesses are tan or light brown and were sold as an accessory with the following tree stands or ladders: Viper X5, Goliath X5, Razor X5, Summit 180 o, Bushmaster X5, Broadhead Backpacker, Bullet Backpacker, Clearshot, Openshot, and MegaSampson. Only harnesses with "Manufactured in 2005," and "Made in China" printed on a label on the harness tether are included in this recall. Sold at: Sporting goods stores nationwide from June 2005 through May 2006 for between $200 and $300 for the tree stand including the harness. Manufactured In: China Remedy: Consumers should immediately stop using the recalled harnesses and contact the firm for a free replacement harness. Consumer Contact: For more information, contact Summit Treestands LLC at (800) 353-0634 between 8 a.m. and 5 p.m. ET, or visit www.harnessrecall2005.com or www.summitstands.com Read more.
These camming anchors or "Alien Cams" are devices used as both a precautionary measure to stop a climber in the event of falls, or it is used to actually support the climber. Climbers insert the device into cracks or crevasses in rock and it grips the sides of the crack. The recalled units are marked with a small center punch dimple at the base of the round ball where the axle goes through the cable eye. They have production dates, from November 2004 (written as 1104) through December 2005 (written as 1205), which can be found on the bottom of the handle puller. Read more.
Both models of avalanche transceivers are plastic and measure 5.5-inches by 2.5-inches by 1-inch. The M1 has a navy blue body and a yellow volume control switch. The M2 avalanche transceiver comes in two colors: glacier white (grey) with a red volume control switch, and orange with a grey volume control switch. The model name and "ORTOVOX" are written on the front of the transceivers. Read more.
Two types of descenders, which are used in recreational wall climbing, are included in this recall: Redpoint and Auto-Belay descenders. The descenders consist of a round metal housing into which a retractable red strap (Redpoint) or steel cable (Auto-Belay) is coiled. The front of each descender's round metal housing includes a red label (Redpoint) or green label (Auto-Belay) with the name of the product. A label on the back of the product's housing includes the descender's date of manufacture, last service date, and product number. Redpoint Descenders are identified with product numbers 10024873, 10027646 or 10027798. Auto-Belay Descenders are identified with the product number 10021806. Redpoint Descenders manufactured or serviced from August 27, 2004 through April 6, 2005 are included in the recall. Auto-Belay Descenders serviced from August 27, 2004 through April 6, 2005 are included in the recall. Read more.
