Recalls: Tools and Hardware
The recall only involves Makita GA7011C 7-inch angle grinders. The grinder's model number and serial number are located on the silver nameplate which is located above the trigger switch. The last four digits of the serial numbers of the recalled grinders are in the following ranges: Read more.
The recall involves Makita DCS6401 and DCS7901-model chain saws in which the last five digits of the serial numbers are within the following ranges: Read more.
The recall involves DOLMAR PS6400 and PS7900-model chain saws in which the last five digits of the serial numbers are within the following ranges: Read more.
The recall involves certain MAC-brand 14.4 Volt and 18.0 Volt 3/8-inch drive cordless drill/drivers. The 14.4 Volt units have part number CDD14438 or CDD14438-Kit and the 18.0 Volt units have Part Number CDD18012 or CDD18012-KIT. The part number can be found on the side of the drill near the logo. Read more.
Only DeWALT D55143 three-gallon hand-carry oil free air compressors with the following date codes: 200448, 200453, 200502 through 200505, 200508, and 200509 are included in the recall. The date code is printed on the name plate on the rear air tank of the unit. Units marked with an "R" on the end cap of the unit are not included in this recall. Read more.
The recall involves new DeWALT D51844 and D51845 Heavy-Duty 20° Full Round Head Framing Nailers, and new DeWALT Model D51722 Heavy Duty 31° Clipped Head Framing Nailers. The recalled units have the following date codes: 200203, 20024, 200217, 200302, 200304, 200308, 200315, 200325, 200329, 200343, 200403, 200404, 200406, 200407, 200412, 200413, 200415, 200416 and 200417. The location of the date code is shown on the photograph below. The new units have a rework date code of 200449DM, 200450DM, 200451DM or 200452DM on the carton. The recall also involves reconditioned DeWALT D51844R and D51845R Heavy-Duty 20° Full Round Head Framing Nailers, and reconditioned DeWALT Model D51822R and D51823R Heavy Duty 31° Clipped Head Framing Nailers, with date codes 200423 through 200509. The date codes on all of the units are located in the area shown on the photograph below. Read more.
The recall circular saws include the BOSCH CS10, CS20 and CS20-XC models, which can be identified on the product nameplate mounted on the top of the motor housing. The recalled models do not have an asterisk (*) in the serial number box. The circular saw uses a 7¼-inch blade and has a blue handle and motor enclosure, and a metal guarding system. The name "BOSCH" is printed on the blade guard. Read more.
The rip fence on these saws is made of silver extruded aluminum, is 31inches in length, and has an over-locking handle with a black die-cast aluminum head. They were included with Craftsman table saw model number 137.21830. Read more.
